top of page

Case Study: Custom 3D-Printed Gel Combs for Research and Teaching Labs

21 hours ago
1 min read

Product: NDN GelKit · Sector: Research and teaching labs · In use: Linköping University, January 2024 · Variants: six configurations from one model

Two green 3D-printed gel combs in an agarose gel casting tray

The problem

Every lab running DNA or protein gels needs combs with the right number of wells, the right width and the right thickness. Original combs are expensive, easy to lose and come in only a few sizes.

What we did

  • Built one parametric comb-and-tray generator in 3DJ, our browser CAD studio, so a new size is a parameter change rather than a redesign.

  • Made ready-to-print sets: 8-, 12- and 15-well combs, a 9 mm pitch comb that lines up with multichannel pipettes, a 2-well preparative comb and a classroom set.

  • Added the details that matter on the bench: specs engraved on every comb, tapered teeth for clean wells, tray slots for repeatable positioning and a printed scale on the tray edge.

Six NDN GelKit comb and casting tray configurations rendered in 3DJ

The result

Our printed combs have been used in a casting tray at Linköping University (January 2024). Six GelKit configurations now come from a single model, and we design pipette stands, racks and replacement parts for existing equipment the same way.

Need a lab part in a different size?

Send a photo, your equipment dimensions or a short description. We model it, send you a 3D preview to check, then print it in the material your work needs.


For research and teaching use only. Not a medical device and not intended for diagnostic or clinical use.

Comments


bottom of page