Case Study: A Discontinued Boat Part, Rebuilt from Phone Photos in a Week
Client: Malta Yachting · Sector: Marine · Timeline: 23–30 September 2026 · Result: the printed cradle fits the real handset

The problem
Malta Yachting needed a replacement for the cradle that holds an AutoAnchor windlass remote on the bulkhead. There was no drawing and no spare part in stock. All we had were phone photos, some with a ruler, and product listings.
What we did
Measured from the photos with height-aware scaling. A ruler only gives the scale for one plane: using it for the raised lips would have over-read them by 7.7%, about 3.7 mm.
Designed three iterations. The first was 6 mm too wide, the second fixed the overall geometry, and the third added the step, undercut and lead-in we found in close-up photos.
Checked snap-fit strain before printing, and designed a fit coupon that tests the critical arms with about 44% less material than the full part.
Verified the model as a single watertight shell, then printed the easy-snap version in ASA.

The result
On 30 September 2026 the third version was fit-tested on the actual handset: it fits. Filament cost was under €0.50 per part (material only, excluding design and machine time). Long-term UV and repeated-insertion tests are the next step.
Read the full engineering story: From Phone Photos to a Part That Fits.
Have a part nobody makes any more?
Send clear photos with a ruler in the frame and a note on how the part is used. We will tell you what we can measure, what is uncertain and what a first prototype should test. No 3D file needed.
Independent replacement design. AutoAnchor names identify the original part; no OEM affiliation is implied.






Comments